Fast swap
Rear-mounted, minimal tools. Keep the cabinet/fascia intact.
Universal Power Board for absorption fridges
Drop-in controller to bring failing gas fridges back to life — stable 12V logic, safer wiring, and clean retrofit for Dometic/Thetford families.
Plug-in replacement*
12V logic
Works with existing eyebrow
What it is
A sealed, drop-in control board that replaces fragile OEM bricks and stabilises ignition/power paths — without changing the cabinet or fascia.
- Simple wiring: power, solenoid, flame+spark, switch/LED.
- Epoxy-potted for humidity and vibration resistance.
- Designed to avoid DC-mode battery drain issues.
Why this board
Stable ignition & control
Cleans up weak power paths that cause intermittent lighting.
Future upgrade path
Designed to coexist with a later 12V compressor retrofit.
Failure gallery
Why OEM bricks fail — and why a sealed board is safer.
Highlights & specs
What you get
Reliable operation, simplified wiring, reduced risk of battery issues — a modern, safe, simple controller kit.
- Universal with EU-style GV100 gas solenoids & flame-rectification sensors.
- Only four connections: power, solenoid, flame+spark, and switch/LED.
- Epoxy-potted to resist humidity, vibration, and wear.
- Designed to avoid DC-mode battery drain issues.
Compatibility
Dometic RM7/RM8/RMD/RMS families and Thetford N-Series (verify wiring & sensors before ordering).
Intended as a replacement for fragile eyebrow/control bricks and their connectors.
Install
Mount at the rear of the cabinet; keep fascia and insulation intact. Quick-start wiring map included.
Value
OEM boards often cost €250–€300 and are scarce; this kit is €149 and in stock.
FAQ
Will this replace my dead eyebrow panel?
In many cases you'll still use the existing eyebrow; this board focuses on power/control reliability. For specific panel obsolescence, see the Dometic/Thetford guides.
Can I upgrade to 12V compressor later?
Yes — this board is designed not to block a future TwinDrive + QuadPhase retrofit path.